Steris Reliance 444 Service Manual

Posted on  by 

This on-site training for, equipment technicians, will provide you with the knowledge to operate and perform maintenance on the Reliance® 444™ Washer/Disinfector. Course Goal: This course provides the student with an in depth understanding of how to operate the Reliance 444 Washer/Disinfector and perform troubleshooting and adjustments. Table of Contents Service and Maintenance Procedures 129359-452, Volume 1 A WORD FROM STERIS CORPORATION This manual contains important information on proper use and maintenance of this sterilizer. All operators and department heads are urged to carefully review and become familiar with the warnings, cautions and instructions contained herein.

One moment please...
Not A Member?Sign Up
2 RepliesCustomer reports every now and then there is water in the chamber at the end of cycle. I have checked the drain valve operation and it is working properly. The water fill valves are not leaking by. I have sat and watched this unit run over and over and of course will not do it when I am onsite. I am thinking about rebuilding the drain valve and see what happens. Any other ideas out there? RE: STERIS - Reliance 444 Series
4 Replies

i have amsco relience 444 washer, error generates (pure h20 tank failed to reach temp).

can any one guide me

RE: STERIS - Reliance 444 Series5 Replies

What is the gauge of the steel cable? And what tool do you use to secure it?

RE: STERIS - Reliance 444 Series1 Reply

I have a reliance 444 washer/disinfector and I need to know what is the recommended check to test the effectiveness of the washer. We have two types but I'm not sure which one is the best...we have the ruhof clean check and a steris one. What is recommended to monitor the reliance 444?

RE: STERIS - Reliance 444 Series2 RepliesReliance

This is an alarm I'm getting on the Genfore Washer. Can anyone tell me where to find a reset switch?

RE: STERIS - Reliance 444 Series3 Replies

Does the Sterils Reliance 444 have an alarm mechanism if there is no detergent being dispensed during that part of the cycle? We have 3 of these washers with one large barrel of detergent that dispenses to all 3 however there is no way to determine which washer is drawing the detergent. We mark the barrel and it goes down but we can't know which washer or how much is going through. Instruments at times come out of a cycle where the parameters on the print out appear fine but the instruments are greasy and smell like blood even though the challenge testing passed.

RE: STERIS - Reliance 444 Series14 Replies

We are wanting to do the basic PM's in house now. If anyone has a copy please let me know.

Thanks

RE: STERIS - Reliance 444 Series3 Replies

How can I set the motor speed from low to high?

RE: STERIS - Reliance 444 Series444

Steris Reliance 444 Service Manual Instructions

1 ReplySteris amsco reliance 444 service manual

I have the Amsco washer sterilizer model 444. I use it for teaching. I need to use it with out power. Is there a way to manually override the door latch to open the sterilizer with out power?

RE: STERIS - Reliance 444 Series0 Replies

starts cycle,

fails after wash 1.

cycle aborts:

sump failed to reach set temp

Steris Reliance 444 Service Manual Download

RE: STERIS - Reliance 444 Series

Coments are closed